Orange Pi5 kernel

/* SPDX-License-Identifier: GPL-2.0 */
/******************************************************************************
 *
 * Copyright(c) 2007 - 2017 Realtek Corporation.
 *
 * This program is free software; you can redistribute it and/or modify it
 * under the terms of version 2 of the GNU General Public License as
 * published by the Free Software Foundation.
 *
 * This program is distributed in the hope that it will be useful, but WITHOUT
 * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
 * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
 * more details.
 *
 *****************************************************************************/
/* ***** temporarily flag ******* */
#define CONFIG_SINGLE_IMG

/* #define CONFIG_DISABLE_ODM */
/* for FPGA VERIFICATION config */
#define RTL8188E_FPGA_TRUE_PHY_VERIFICATION 0

/* ***** temporarily flag ******* */
/*
 * Public  General Config
 */
#define AUTOCONF_INCLUDED
#define RTL871X_MODULE_NAME "88EU"
#define DRV_NAME "rtl8188eu"

#define CONFIG_USB_HCI

#define PLATFORM_LINUX

/* #define CONFIG_IOCTL_CFG80211 */

#if defined(CONFIG_PLATFORM_ACTIONS_ATM702X)
	#ifndef CONFIG_IOCTL_CFG80211
		#define CONFIG_IOCTL_CFG80211
	#endif
#endif

#ifdef CONFIG_IOCTL_CFG80211
	/* #define RTW_USE_CFG80211_STA_EVENT */ /* Indecate new sta asoc through cfg80211_new_sta */
	#define CONFIG_CFG80211_FORCE_COMPATIBLE_2_6_37_UNDER
	/* #define CONFIG_DEBUG_CFG80211 */
	/* #define CONFIG_DRV_ISSUE_PROV_REQ */ /* IOT FOR S2 */
	#define CONFIG_SET_SCAN_DENY_TIMER
#endif

/*
 * Internal  General Config
 */

/* #define CONFIG_H2CLBK */

#define CONFIG_EMBEDDED_FWIMG


#ifdef CONFIG_EMBEDDED_FWIMG
	#define	LOAD_FW_HEADER_FROM_DRIVER
#endif
/* #define CONFIG_FILE_FWIMG */

#define CONFIG_XMIT_ACK
#ifdef CONFIG_XMIT_ACK
	#define CONFIG_ACTIVE_KEEP_ALIVE_CHECK
#endif
#define CONFIG_80211N_HT

#define CONFIG_RECV_REORDERING_CTRL

 #define CONFIG_SUPPORT_USB_INT
 #ifdef CONFIG_SUPPORT_USB_INT
/* #define CONFIG_USB_INTERRUPT_IN_PIPE */
#endif

#ifdef CONFIG_POWER_SAVING
	#define CONFIG_IPS
	#ifdef CONFIG_IPS
	/* #define CONFIG_IPS_LEVEL_2 */	 /* enable this to set default IPS mode to IPS_LEVEL_2 */
	#endif
	#define SUPPORT_HW_RFOFF_DETECTED

	#define CONFIG_LPS
	#if defined(CONFIG_LPS) && defined(CONFIG_SUPPORT_USB_INT)


	/* #define CONFIG_LPS_LCLK */
	#endif

	#ifdef CONFIG_LPS_LCLK
	/* #define CONFIG_XMIT_THREAD_MODE */
	#endif
#endif /* CONFIG_POWER_SAVING */

	/*#define CONFIG_ANTENNA_DIVERSITY*/



	/* #define CONFIG_CONCURRENT_MODE */
	#ifdef CONFIG_CONCURRENT_MODE
		#define CONFIG_RUNTIME_PORT_SWITCH

		#define CONFIG_TSF_RESET_OFFLOAD			/* For 2 PORT TSF SYNC. */
	#endif

	#define CONFIG_IOL
/* #else */	/* #ifndef CONFIG_MP_INCLUDED */

/* #endif */	/* #ifndef CONFIG_MP_INCLUDED */

#define CONFIG_AP_MODE
#ifdef CONFIG_AP_MODE

	/* #define CONFIG_INTERRUPT_BASED_TXBCN */ /* Tx Beacon when driver BCN_OK ,BCN_ERR interrupt occurs */
	#if defined(CONFIG_CONCURRENT_MODE) && defined(CONFIG_INTERRUPT_BASED_TXBCN)
		#undef CONFIG_INTERRUPT_BASED_TXBCN
	#endif
	#ifdef CONFIG_INTERRUPT_BASED_TXBCN
		/* #define CONFIG_INTERRUPT_BASED_TXBCN_EARLY_INT */
		#define CONFIG_INTERRUPT_BASED_TXBCN_BCN_OK_ERR
	#endif

	#define CONFIG_NATIVEAP_MLME
	#ifndef CONFIG_NATIVEAP_MLME
		#define CONFIG_HOSTAPD_MLME
	#endif
	#define CONFIG_FIND_BEST_CHANNEL
#endif

#define CONFIG_P2P
#ifdef CONFIG_P2P
	/* The CONFIG_WFD is for supporting the Wi-Fi display */
	#define CONFIG_WFD

	#define CONFIG_P2P_REMOVE_GROUP_INFO

	/* #define CONFIG_DBG_P2P */

	#define CONFIG_P2P_PS
	#define CONFIG_P2P_OP_CHK_SOCIAL_CH
	#define CONFIG_CFG80211_ONECHANNEL_UNDER_CONCURRENT  /* replace CONFIG_P2P_CHK_INVITE_CH_LIST flag */
	/*#define CONFIG_P2P_INVITE_IOT*/
#endif

/* Added by Kurt 20110511 */
#ifdef CONFIG_TDLS
	#define CONFIG_TDLS_DRIVER_SETUP
/*	#ifndef CONFIG_WFD */
/*		#define CONFIG_WFD */
/*	#endif */
/*	#define CONFIG_TDLS_AUTOSETUP */
	#define CONFIG_TDLS_AUTOCHECKALIVE
	/* #define CONFIG_TDLS_CH_SW */	/* Enable this flag only when we confirm that TDLS CH SW is supported in FW */
#endif


#define CONFIG_SKB_COPY	/* for amsdu */

/* #define CONFIG_RTW_LED */
#ifdef CONFIG_RTW_LED
	#define CONFIG_RTW_SW_LED
	#ifdef CONFIG_RTW_SW_LED
		/* #define CONFIG_RTW_LED_HANDLED_BY_CMD_THREAD */
	#endif
#endif /* CONFIG_RTW_LED */

#ifdef CONFIG_IOL
	#define CONFIG_IOL_NEW_GENERATION
	#define CONFIG_IOL_READ_EFUSE_MAP
	/* #define DBG_IOL_READ_EFUSE_MAP */
	/* #define CONFIG_IOL_LLT */
	#define CONFIG_IOL_EFUSE_PATCH
	/* #define CONFIG_IOL_IOREG_CFG */
	/* #define CONFIG_IOL_IOREG_CFG_DBG */
#endif


#define CONFIG_GLOBAL_UI_PID

#define CONFIG_LAYER2_ROAMING
#define CONFIG_LAYER2_ROAMING_RESUME
/* #define CONFIG_ADAPTOR_INFO_CACHING_FILE */ /* now just applied on 8192cu only, should make it general... */
/* #define CONFIG_RESUME_IN_WORKQUEUE */
/* #define CONFIG_SET_SCAN_DENY_TIMER */
#define CONFIG_LONG_DELAY_ISSUE
#define CONFIG_NEW_SIGNAL_STAT_PROCESS
/* #define CONFIG_SIGNAL_DISPLAY_DBM */ /* display RX signal with dbm */
#ifdef CONFIG_SIGNAL_DISPLAY_DBM
/* #define CONFIG_BACKGROUND_NOISE_MONITOR */
#endif
#define RTW_NOTCH_FILTER 0 /* 0:Disable, 1:Enable, */

/*
 * Interface  Related Config
 */

#ifndef CONFIG_MINIMAL_MEMORY_USAGE
	#define CONFIG_USB_TX_AGGREGATION
	#define CONFIG_USB_RX_AGGREGATION
#endif

/* #define CONFIG_REDUCE_USB_TX_INT */		/* Trade-off: Improve performance, but may cause TX URBs blocked by USB Host/Bus driver on few platforms. */
/* #define CONFIG_EASY_REPLACEMENT */

/*
 * CONFIG_USE_USB_BUFFER_ALLOC_XX uses Linux USB Buffer alloc API and is for Linux platform only now!
 */
/* #define CONFIG_USE_USB_BUFFER_ALLOC_TX */	/* Trade-off: For TX path, improve stability on some platforms, but may cause performance degrade on other platforms. */
/* #define CONFIG_USE_USB_BUFFER_ALLOC_RX */	/* For RX path */
#ifdef CONFIG_USE_USB_BUFFER_ALLOC_RX

#else
	#define CONFIG_PREALLOC_RECV_SKB
	#ifdef CONFIG_PREALLOC_RECV_SKB
		#define CONFIG_FIX_NR_BULKIN_BUFFER /* only use PREALLOC_RECV_SKB buffer, don't alloc skb at runtime */
	#endif
#endif

/*
 * USB VENDOR REQ BUFFER ALLOCATION METHOD
 * if not set we'll use function local variable (stack memory)
 */
/* #define CONFIG_USB_VENDOR_REQ_BUFFER_DYNAMIC_ALLOCATE */
#define CONFIG_USB_VENDOR_REQ_BUFFER_PREALLOC

#define CONFIG_USB_VENDOR_REQ_MUTEX
#define CONFIG_VENDOR_REQ_RETRY

/* #define CONFIG_USB_SUPPORT_ASYNC_VDN_REQ */


/*
 * HAL  Related Config
 */

#define RTL8188E_RX_PACKET_INCLUDE_CRC	0

#define SUPPORTED_BLOCK_IO


/* #define CONFIG_ONLY_ONE_OUT_EP_TO_LOW	0 */

#define CONFIG_OUT_EP_WIFI_MODE	0

#define ENABLE_USB_DROP_INCORRECT_OUT


#define DISABLE_BB_RF	0

/* #define RTL8191C_FPGA_NETWORKTYPE_ADHOC 0 */

#ifdef CONFIG_MP_INCLUDED
	#define MP_DRIVER 1
	#define CONFIG_MP_IWPRIV_SUPPORT
	/* #undef CONFIG_USB_TX_AGGREGATION */
	/* #undef CONFIG_USB_RX_AGGREGATION */
#else
	#define MP_DRIVER 0
#endif


/*
 * Platform  Related Config
 */
#if defined(CONFIG_PLATFORM_ACTIONS_ATM702X)
	#ifdef CONFIG_USB_TX_AGGREGATION
		#undef CONFIG_USB_TX_AGGREGATION
	#endif
	#ifndef CONFIG_USE_USB_BUFFER_ALLOC_TX
		#define CONFIG_USE_USB_BUFFER_ALLOC_TX
	#endif
	#ifndef CONFIG_USE_USB_BUFFER_ALLOC_RX
		#define CONFIG_USE_USB_BUFFER_ALLOC_RX
	#endif
#endif


#ifdef CONFIG_USB_TX_AGGREGATION
/* #define	CONFIG_TX_EARLY_MODE */
#endif

#ifdef CONFIG_TX_EARLY_MODE
#define	RTL8188E_EARLY_MODE_PKT_NUM_10	0
#endif

/*#define CONFIG_RF_POWER_TRIM */

#ifdef CONFIG_GPIO_WAKEUP
	#ifndef WAKEUP_GPIO_IDX
		#define WAKEUP_GPIO_IDX 7
	#endif
#endif

/*
 * Debug Related Config
 */
#define DBG	1

#define CONFIG_PROC_DEBUG

#define DBG_CONFIG_ERROR_DETECT
/* #define DBG_CONFIG_ERROR_DETECT_INT */
#define DBG_CONFIG_ERROR_RESET

/* #define DBG_IO */
/* #define DBG_DELAY_OS */
/* #define DBG_MEM_ALLOC */
/* #define DBG_IOCTL */

/* #define DBG_TX */
/* #define DBG_XMIT_BUF */
/* #define DBG_XMIT_BUF_EXT */
/* #define DBG_TX_DROP_FRAME */

/* #define DBG_RX_DROP_FRAME */
/* #define DBG_RX_SEQ */
/* #define DBG_RX_SIGNAL_DISPLAY_PROCESSING */
/* #define DBG_RX_SIGNAL_DISPLAY_SSID_MONITORED "jeff-ap" */



/* #define DBG_SHOW_MCUFWDL_BEFORE_51_ENABLE */
/* #define DBG_ROAMING_TEST */

/* #define DBG_HAL_INIT_PROFILING */

/* #define DBG_MEMORY_LEAK */

/* TX use 1 urb */
/* #define CONFIG_SINGLE_XMIT_BUF */
/* RX use 1 urb */
/* #define CONFIG_SINGLE_RECV_BUF */
#define	DBG_RX_DFRAME_RAW_DATA